Video

Step by step installation method

STEP.01

Cut the pipes

Cut the pipes perpendicular to the axes.
Remove burs using sand papers on the pipe surface

STEP.02

Marking

Insert the pipes into marking tool.
Mark the pipes while keeping the pipes be securely inserted to the end of the marking tool.

STEP.03

Insert the pipes

Insert pipes deep enough to the fitting until mark “J” disappears.

STEP.04

Place the tool

Mount the right size of inserts to the tool and place the tool around the fitting.
Mark “M” should not be visible at the right position.

STEP.05

Swage and done

Run the hydraulic pump and swage the fitting.
Remove the tool and check the mark “MJ”.
The upper bar on the mark “J” should not end out of the fitting.

Video

Step by step installation method

STEP.01

Cut the pipes

Cut the pipes perpendicular to the axes.
Remove burs using sand papers on the pipe surface

STEP.02

Marking

Insert the pipes into marking tool.
Mark the pipes while keeping the pipes be securely inserted to the end of the marking tool.

STEP.03

Insert the pipes

Insert pipes deep enough to the fitting until mark “J” disappears.

STEP.04

Place the tool

Mount the right size of inserts to the tool and place the tool around the fitting.
Mark “M” should not be visible at the right position.

STEP.05

Swage and done

Run the hydraulic pump and swage the fitting.
Remove the tool and check the mark “MJ”.
The upper bar on the mark “J” should not end out of the fitting.